• A thick filler for cracks and dents in driveway, parking lot, and blacktop surfaces
  • Provides lasting protection
  • Latex enhanced for longer life


Login / Register for Additional Discounts

  • A thick filler for cracks and dents in driveway, parking lot, and blacktop surfaces
  • Provides lasting protection
  • Latex enhanced for longer life


DESCRIPTION. PRODUCT NO. 210-D is an undercoating used as a crack filler for PRODUCT NO.555 Driveway and Parking Lot Sealer. PRODUCT NO. 210-D, which is black in color, promotes proper adhesion to the substrate. This coating forms a thick, crack-resistant shield that resists peeling and cracking.

USES. PRODUCT NO. 210-D is especially recommended as a driveway crack filler prior to sealing.

SURFACE PREPARATION. Surfaces to be coated must be cleaned thoroughly of all scales, loose mortar, rust, dirt, oil, grease and all foreign matter using a wire brush, sand blast or other materials in keeping with good practice. Dusty or porous masonry should be primed using the product at a 10% dilution rate with water and allowed to dry thoroughly before coating with emulsion. Likewise, old roofs and all metal should be primed prior to coating.

APPLICATION. PRODUCT NO. 210-D should be stirred in the container and then applied by soft bristle brush, long nap roller or suitable spray equipment. Adequate protection for most surfaces is obtained by the use of not less than 2-6 gallons of PRODUCT NO. 210-D per 100 sq. ft. of surface area. For spraying, use a heavy duty airless spray unit (tip size approximately 60 thousandths of an inch). Also, follow manufacturer’s recommendations for spraying Elastomeric Emulsions. PRODUCT NO. 210-D should be applied under normal environment conditions without thinning. All Elastomeric Emulsion Coating’s “set” by dehydration. However, the rate of drying is dependent upon the thickness of application, temperature, humidity, and rate of air movement. Product should not be applied when raining or when rain or frost forecast within 24 hours. Apply only when temperature is 45 degrees Fahrenheit and rising.


CLEAN-UP. All equipment can be cleaned immediately after use with soap and water. Also, dried material can be cleaned with mineral spirits or biodegradable terpene solvent.

Additional information

Weight 21.7724 lbs
Dimensions 13 × 13 × 17 cm
Weight per Gallon

9.0 lbs

Solids by Weight*


Drying Time 1/16″ wet film (normal conditions)

Touch 5 hrs


Wet: Non-Flammable, Dry: When exposed to a flame the film will self-extinguish and char in place.


< 50 grams/liter


Percentages stated are + or – 5%

Approx. Shipping Weights:

(All approximate weights include container)
5 gallons 48 lbs.




1 Gallon, 5 Gallon

Share your thoughts!

Let us know what you think...

What others are saying

There are no contributions yet.



Continue as a Guest