DESCRIPTION. Dura-Coat Roof Coating is an ultra-white 100% acrylic elastomeric roof coating. This premium grade coating offers maximum protection against sun and weather, as its bright finish enables it to reflect the sun’s heat and harmful UV rays. This product forms a thick, rubber-like shield that expands and contracts over 300% to prevent roof damage. It resists cracking, peeling, and mildew while offering unbeatable weatherproof protection and excellent resistance to lifting under ponding water conditions.
USES. Dura-Coat Roof Coating works over mineral surface roofing, aged aluminum, tar, asphalt, or hot-applied built-up roofing after application of PRODUCT NO. 210 emulsion. Reinforce all large cracks and seams with woven polyester fabric embedded into PRODUCT NO. 210. This elastomeric roof coating will work over most previously white-coated sound roof surfaces. PRODUCT NO. 6000 is recommended for EPDM roofs or areas subject to unusually severe moisture conditions such as valleys, around roof drains, low spots or in any area where water is expected to be trapped on a roof.
SURFACE PREPARATION. All surfaces must be dry and free of dust, oil, loose granules, gravel or peeling paint and all other foreign matter. Clean rusty metal with a wire brush and prime with PRODUCT NO. 101. Asphalt primer prior to application of PRODUCT NO. 210 emulsion and PRODUCT NO. 6000 Dura-Coat Roof Coating. Polyurethane Foam Roofs: Prime surface with PRODUCT NO. 295 surface conditioner prior to application of PRODUCT NO. 6000. Pressure washing surfaces is recommended for best results.
Surfaces with any mildew growth or stains should be cleaned with a bleach solution (2 parts water to one part bleach) prior to applying this product. Rinse all surfaces before application.
APPLICATION. Material should be stirred in the container and applied by a soft-bristled brush or broom, a long nap roller or suitable spray equipment (minimum working pressure of 3000 PSI for airless sprayer). Coverage rates vary depending on porosity of surface as well as roof pitch. Use a brush, roller or spray to apply two coats at right angles to previous coat. Let first coat dry before applying second coat. Also, rinse tools often with water. To protect most surfaces, use two gallons of Dura-Coat Roof Coating per 100 sq. ft., applied in two coats.
Allow 24 to 72 hours depending on weather before applying second coat.
Do not apply unless temperature is 55°F. Do not apply when rain or frost has been forecast within 24 hours. Finally, conditions of high humidity will prevent curing in the usual four hours. Avoid heavy foot traffic.
KEEP PRODUCT FROM FREEZING.
DO NOT APPLY TO ANY SURFACES THAT CONTAIN SILICONE.
CLEAN-UP. Clean brushes, tools and other equipment with soapy water immediately after use. Dried film may require paint remover.
|Dimensions||13 × 13 × 17 cm|
|Weight per Gallon||
|Solids by Weight*||
|Drying Time (50% Relative Humidity & 70°F)||
Touch: 4 hrs, Firm: 8 hrs
≤ 100 g/l
> 450 PSI
Percentages stated are + or – 5%
|Approx. Shipping Weights:||
(All approximate weights include container)